RhinoScreen™ Dry Stencil Film
Description
Highly efficient stencil making system that eliminates the need for a film positive, emulsion, capillary film, exposure and drying time
Procedure
Create art work and convert to a negative image
Using a laser printer or copier, print image on the coated side of the paper identified as the Imaging Sheet
Feed paper into the copier or printer with the short dimension first (grain long). For best fusing results, select a heavy paper setting
Transferring
Marry the Imaged Sheet with the Transfer Sheet. This will apply the transfer coating to the imaged area, only.
Heat Press for 20 seconds at 225° F using high pressure with the Image Sheet on top.
Separate the papers while still Hot (Hot Peel). The stencil is ready to be applied to the screen. Place release paper on the heat press bed. Place clean, dry screen onto heat press, print side up. Place the imaging sheet face down onto the bottom surface of the screen.
Heat Press: 30 seconds at 350°F using heavy pressure.
Wait 3 to 4 minutes before peeling the carrier sheet (cold peel). Once peeled, the screen is created.
Block the screen with RhinoBlock and begin printing.
Repeat these steps for each color if printing a multi- color job.
Once printing is completed, apply RhinoClean Screen Wash to remove the ink. To remove the stencil, use high pressure water. If needed, apply HR 2800 Haze Remover to make the screen look like new.
| RS8511-10 | 10 pack | 8.5" x 11" | $19.55 |
| RS8511-50 | 50 pack | 8.5" x 11" | $95.50 |
| RS8511-100 | 100 pack | 8.5" x 11" | $175.50 |